Jun

18Tue

3D Printing Meetup June Topic: Bed Adhesion & The Perfect First Layer

Brandon Hart @brandonhart

Maple Ventures - West Des Moines, IA
1201 Maple St

Tue, Jun 18, 2019 at 12:00 AM - 2:00 AM

View event
meetup.com/Des-Moines-3D…

View event
meetup.com/Des-Moines-3D…

Tags

Share with friends

About

Those of you who have any experience with 3D printing know that the most important part of any 3D print is the very first layer. How well does it stick to the print bed, will it warp, will it fall over, and how well will it break off of the bed when it's done? So much depends on this crucial first layer. So how can you ensure that this first layer goes down properly? What types of build surfaces work with what types of materials? Let's discuss it and figure it out together!